Accessory Wiring Junction Block Replacement

Accessory Wiring Junction Block Replacement

Removal Procedure





1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26 - 3.8L) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS4 - 5.3L) (Service and Repair) .
2. Remove the instrument panel (I/P) compartment access hole cover.




3. Disconnect the body wiring harness from the accessory wiring junction block. Pull the harness away from the block for access.
4. Open the I/P compartment. Access the junction block bolt through the open I/P compartment. Remove the junction block bolt.




5. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the I/P.
6. Remove the junction block.



Installation Procedure





1. Seat the bottom junction block tabs and snap the top of the junction block to the passenger knee bolster.





Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the junction block bolt.

Tighten the junction block bolt to 10 N.m (89 lb in).

3. Close the I/P compartment.
4. Connect the body wiring harnesses to the junction block.

Tighten the connector bolt to 2.5 N.m (22 lb in).





5. Install the I/P compartment access hole cover.
6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26 - 3.8L) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS4 - 5.3L) (Service and Repair) .