Without Variable Camshaft Phasing

Accelerator Pedal Position Sensor Replacement

Removal Procedure




Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).
1. Disconnect the negative battery cable.
2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
3. Remove the 3 accelerator pedal retaining nuts (1).
4. Remove the accelerator pedal (2).

Installation Procedure




1. Position the accelerator pedal.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the 3 accelerator pedal retaining nuts (1).

Tighten the accelerator pedal retaining nuts to 19 Nm (14 lb ft).

3. Connect the ETC connector to the accelerator pedal.
4. Connect the negative battery cable.