LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G3 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.6L (LXV) >> Diagnostic Information and Procedures >> DTC P0128 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the ECT sensor.
  2. Ignition OFF, test for less than 5 ohms between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify the scan tool ECT sensor parameter is at -40°C (-40°F).
    • If greater than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Ignition ON, clear the DTC information with a scan tool.
    5. IMPORTANT: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.
  5. Install a 1A fused jumper wire between the signal circuit terminal B and ground. Verify the scan tool ECT sensor parameter is greater than 128°C (262°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. If all circuits test normal, test or replace the ECT sensor.
scientia non olet · About LEMON Manuals