Circuit/System Testing
- Ignition OFF, disconnect the fuel pump relay.
- Verify a test lamp illuminates between the relay ground circuit terminal 85 and B+.
- If the test lamp does illuminate, repair the ground circuit for an open/high resistance.
- Connect a test lamp between the control circuit terminal 86 and ground.
- Command the fuel pump relay ON with a scan tool. The test lamp should turn ON and OFF with each command.
- If the test lamp is always ON, test the control circuit for a short to voltage. If circuit tests normal, replace the ECM.
- If the test lamp is always OFF, test the control circuit for a short to ground, or an open/high resistance. If circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the fuel pump relay.