Installation Procedure
- Inspect each spark plug gap. Adjust each plug as needed.
Specification: Spark plug gap: 1.524 mm (0.060 in).
- Hand start the spark plugs in the corresponding cylinders.
- Tighten the spark plugs. Tighten the engine spark plug on a NEW cylinder head to 20 N.m (15 lb ft) and the engine spark plug on subsequent installations to 15 N.m (11 lb ft).
- Install the spark plug wires. Refer to Spark Plug Wire Replacement .
- Install the engine cover. Refer to Engine Cover Replacement .
CAUTION:
Refer to Fastener Caution
.