LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G8 GXP, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 6.0L, 6.2L - Introduction >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Throttle Body To Intake Manifold Retaining Bolts
    GM1950738Courtesy of GENERAL MOTORS CORP.
    NOTE: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.
  1. Install a new throttle body to intake manifold gasket (2). Align the locating tab of the gasket with the notch in the manifold.
  2. Install the throttle body (1) to the intake manifold.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the throttle body to intake manifold retaining bolts (3) and tighten to 12 N.m (106 lb in).
  4. Install the electrical wire harness connector from the throttle body.
  5. Install the air intake duct to the throttle body. Refer to Air Cleaner Inlet Duct Replacement .
  6. If re-programming is required, refer to Control Module References .
scientia non olet · About LEMON Manuals