LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2010 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Steering Wheel Position Sensor Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    Fig 1: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  1. Lock the steering column through the access hole in the lower trim cover using J 42640  .
    2. Fig 2: Identifying Intermediate Shaft
    GM1654921Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If replacing the sensor, a new sensor MUST come with a pin installed. If pin is not installed, return and reorder sensor. Do not apply force to the sensor and the bearing assembly in a sideways direction.
    When reusing the sensor you must install a pin into the sensor before it is removed from the steering shaft. By not installing a pin into the sensor it will cause the sensor to lose its centering position and must be discarded.
    Pin diameter must be in the range of 1.0-2.0 mm.
  2. Remove the intermediate shaft from the steering column shaft. Refer to Intermediate Steering Shaft Replacement .
  3. Remove the sensor connector by using a suitable tool in order to pull the connector down around the right side of the steering column for accessibility.
  4. Remove the sensor from the steering shaft.
scientia non olet · About LEMON Manuals