Battery load test

NOTE:

The gravity of electrolyte test provides information about the state of the battery in connection with the battery load test.
A battery test device is required for the load test.
The battery must not be removed or disconnected.
The battery must be charged before the load test is performed.

Carry out battery load test:

Switch ignition off and remove ignition key.
Observe the information in the operating instructions of the battery test device.
Connect the pliers of the test lines to the battery terminal as described in the operating instructions of the test device.
- As the load current varies, the current must be set depending on the battery capacity (operating instructions of test device).
The load test currents can also be referred to in BATTERY LOAD TEST SPECIFICATIONS .

Carry out the battery load test according to the operating instructions and compare to the test result of BATTERY LOAD TEST SPECIFICATIONS .

A minimum voltage is determined by the battery load test depending on the specified battery voltage.

BATTERY LOAD TEST SPECIFICATIONS

Remarks on battery load test:

The battery voltage sinks during this test due to the severe load on the battery.
If the battery is in order, the voltage value only reduces to the minimum voltage.
If the battery is faulty, the battery voltage will sink very quickly below the specified minimum voltage.
After the test has taken place, the low voltage value remains over a long period of time, the voltage increases again slowly.