Hall Sensor Rotor

Tools:

Item Designation Special tool Explanation
A Extractor Commercially available
B Spacer VW 545/2
C Pressure plate VW 402
D Pressure piece 9628

Removal
1. Heat rotor area with a hot-air gun.
Pull off rotor with a commercially available extractor.
Place a spacer, e.g. VW 545/2, between the spindle and camshaft.







Installation
1. Thoroughly clean the rotor mounting surface.
Coat the seat area with Loctite 270.
2. Fit new rotor in the correct position by hand.







3. Use the pressure piece (special tool 9628) to press the rotor onto its seat. Use pressure plate VW 402 as the camshaft support surface on the workshop press.