LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Porsche >> 2003 >> Boxster Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission, Controls, Case) >> Removing And Installing Sealing Ring For Selector Shaft >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removing And Installing Sealing Ring For Selector Shaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove multifunction switch. See REMOVING AND INSTALLING MULTIFUNCTION SWITCH  .
  2. Detach push rod at selector lever.
  3. Drive out roll pin (1) until the selector lever can be pulled off from the shaft.
    Fig 1: Driving Out Roll Pin From Selector Lever
    G03102768Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Pierce sealing ring with small screwdriver and pull out.
    Fig 2: Piercing Sealing Ring With Small Screwdriver
    G03102769Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals