Fault code 16346: Diagnosis/troubleshooting
NOTE:
- Before replacing the control unit, the ground connections, power supply and plug connections on the control unit must be checked.
- After the test drive, read out the fault memory with the Porsche System Tester II No. 9588 again. Additional causes of faults that could damage the transverse lock control unit should be detected and remedied.
DIAGNOSIS TROUBLESHOOTING PROCEDURE
| Work instruction | Display OK | If not OK | |
|---|---|---|---|
| 1 | Replace transverse lock control unit | Please see above note on replacing control units! → End |
|