Fault code 16353: Diagnosis/troubleshooting
NOTE:
Before replacing the control unit, the ground connections, power supply and plug connections on the control unit must be checked. After the test drive, read out the fault memory with the Porsche System Tester II No. 9588 again. Additional causes of faults that could damage the transverse lock control unit should be detected and remedied.
DIAGNOSIS TROUBLESHOOTING PROCEDURE
| Work instruction | Display OK | If not OK | |
|---|---|---|---|
| 1 | Check transverse lock control unit plug connection for proper seating and contact | Go to Step 2 | Connect plug properly to transverse lock control unit → End |
| 2 | Erase fault memory for transverse lock control unit and restart internal function test (ignition ON/test is performed automatically) | → End | If fault is repeated, then: Go to Step 3 |
| 3 | Replace transverse lock control unit | → End | |