Note on adaption

The DME control module must perform a learning and adaptation routine for the throttle valve adjuster if:

• the power supply to the DME control module was interrupted,
• the DME control module connectors were unplugged,
• a new DME control module was installed,
• the throttle valve adjuster was replaced,
• the DME was programmed.

To initiate adaption:

1. Switch on the ignition without starting the engine
2. Perform a "throttle adaptation" under the "System adaptation" column using the 9588 Porsche System Tester II.

The following conditions must be met, otherwise adaptation is not possible:

• Do not press the accelerator (make sure there is no carpet pressing on the accelerator, for example)
• Stationary vehicle
• Battery positive voltage between 10 V and 16 V
• Engine temperature between 5°C and 100°C
• Intake air temperature > 10°C