Possible cause of fault
- The transverse acceleration sensor was not calibrated or was not calibrated correctly (no or incorrect basic setting/adaptation).
Actual value of function integrated in the combination sensor:
- Transverse acceleration sensor
is evaluated and displays an implausible value (implausible signal).
- Internal CAN: Wire faulty (implausible signal)
- Short circuit to ground (electrical fault in electric circuit)
- Short circuit to B+ (electrical fault in electric circuit)
- Open circuit in circuit to control module (electrical fault in electric circuit)
- Transverse acceleration sensor faulty
NOTE:
The transverse and axial acceleration sensor and the rate-of-turn sensor are integrated into the combination sensor housing. If a fault is detected in one of these three sensors, the combination sensor must be replaced. The integrated transverse and axial acceleration sensor must be calibrated after replacement.