SEV MARCHAL Alternators: Overhaul: Disassembly
- Remove brush holder retaining screws and carefully remove brush holder. Scribe a mark on end frames for reassembly reference.
- Remove through bolts. Separate end frames by inserting 2 screwdrivers into notches on sides of alternator.CAUTION: Do not insert screwdrivers deeper than 0.08" (2 mm) or damage may occur to stator windings.
- Remove nuts and washers for positive and negative diode holders from end frame. Carefully remove stator from end frame.
- Hold rotor in a vise using special wood blocks so no damage will occur to rotor. Remove nut, washer, pulley, fan, key and spacer.NOTE: Check direction spacer under pulley fan faces for assembly reference.
- Remove retaining screws from bearing cap. Push rotor shaft from end frame. Press bearing from end frame. Use a puller to remove bearing from slip ring end of rotor.