Track Rod Length

1. Adjust the toe in.
2. Slacken the clip that holds the rack gaiter to the track rod.
3. Slide the rubber gaiters towards the rack-and-pinion housing to expose the groove in which it seals.
4. Measure dimension C. Dimension is the distance between the locknut and the edge of the groove for the gaiter, must never be allowed to exceed 140 mm (5.51 inch).
5. Repeat steps 2 - 4 on the other side of the car.
6. Compare measurement the two values of dimension C. The difference between the two sides of the car must not exceed 2 mm (0.079 inch). The main reasons that dimension C on either side of the car must not vary by more than 2 mm (0.079 inch) are:
^ To avoid. undesirable over-steer when cornering.
^ To avoid exceeding the maximum permissible working angle of the CV joints.
^ To prevent the wheel from rubbing against the wing liner.
7. Adjust, if necessary.

NOTE: The toe-in must be checked after any adjustment of the track rod length.

8. Slide the rubber gaiter back into the groove.
9. Refit the clip.
10. Repeat steps 8 - 9 on the other side of the car.
11. Check the position of the steering wheel.