Ignition Discharge Module: Installation

WARNING: This page is about a different car, the 2002 Saab 9-5, 2002 Saab 9-3, 2001 Saab 9-5, and 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

Apply Krytox to the rubber seals and install the ignition discharge module. See Fig 1 .
Install the 4 screws. See TORQUE SPECIFICATIONS .
Spray the 10-pin ignition discharge module connector with Kontakt 61 contact cleaner. Plug in the connector.

Fig 1: Installing Ignition Discharge Module (4-Cyl)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Coat the rubber seals with Krytox.
Spray the connector with Kontakt 61 contact cleaner. Plug in the connector. See Fig 1 .
Install the ignition discharge module.
Install the cover.

Fig 1: Installing Front Ignition Discharge Module (V6)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Coat the rubber seals with Krytox.
Spray the connectors with Kontakt 61 contact cleaner. Plug the connectors into the ignition discharge module. See Fig 1 .
Install the ignition discharge module.
Plug in the connector to the pressure sensor on the intake manifold. See Fig 2 .
Install the cover.

Fig 1: Installing Rear Ignition Discharge Module (V6)

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Fig 2: Connecting Pressure Sensor To Intake Manifold (V6)

Courtesy of SAAB-SCANIA OF AMERICA, INC.