Installation Procedure

Fig 1: Removing/Installing ORVM & Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the ORVM assembly to the door. Ensure that the retaining clip is fully seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 3 ORVM retaining bolts.
Tighten: Tighten the bolts to 10 N.m (88 lb in).

Fig 2: Removing/Installing Side Door Insulator

Courtesy of GENERAL MOTORS CORP.

Install the side door insulator.
Install the ORVM harness to the door.
Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door .