Conditions For Running The DTC
- DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0300-P0306, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0483, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P060D, P060E, P0641, P0651, P1516, P1621, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
- The Engine Coolant Temperature (ECT) Sensor parameter is more than 70°C (158°F).
- The Engine Speed parameter is between 1,000-3,500 RPM.
- The Ignition 1 Signal parameter is more than 10 volts.
- The Engine Run Time parameter is more than 170 seconds.
- The Loop Status parameter is closed.
- The Throttle Position (TP) Indicated Angle parameter is between 5-60 percent.
- The evaporative emission (EVAP) purge solenoid command is more than 0 percent.
- The Fuel Level Sensor parameter is more than 10 percent.
- The Manifold Absolute Pressure (MAP) Sensor parameter is between 25-104 kPa.
- The Air Flow Calculated parameter is more than 25 g/s.
- DTC P1133 runs once per drive cycle when the above conditions are met for 2 seconds.