Test Description
The number below refers to the step number on the diagnostic table.
- 8: More than 1 ETC system related DTC may set. This is due to the many redundant tests run continuously on this system. Locating and repairing 1 individual condition may correct more than 1 DTC. Keep this in mind when reviewing captured DTC info.
DTC P2119
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views or Engine Controls Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Are any other DTCs set? | - | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | Go to Step 3 |
| 3 |
|
20-30% | Go to Step 6 | Go to Step 4 |
| 4 | Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement
. Did you find any obstructions preventing the throttle blade from returning to the default position? |
- | Go to Step 5 | Go to Step 6 |
| 5 | Remove the obstruction. Did you complete the repair? |
- | Go to Step 7 | - |
| 6 | Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement
. Did you complete the replacement? |
- | Go to Step 7 | - |
| 7 |
|
- | Go to Step 2 | Go to Step 8 |
| 8 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |