Blower Motor Resistor: Service and Repair

Blower Motor Resistor Assembly Replacement

Removal Procedure

1. Remove the right closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Instrument Panel Insulator Panel Replacement - Right Side).




2. Disconnect the blower motor resistor electrical connector (3).
3. Remove the blower motor resistor mounting screws (2).
4. Remove the blower motor resistor (1).

Installation Procedure




1. Install the blower motor resistor (1).

Notice: Refer to Fastener Notice (Fastener Notice).

2. Install the blower motor resistor mounting screws (2).

Tighten the screws to 1.9 Nm (17 in. lbs.).

3. Connect the blower motor resistor electrical connector (3).
4. Install the right closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Instrument Panel Insulator Panel Replacement - Right Side).