LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2011 >> 9-4X 3.0i, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Theft Protection >> Fault diagnosis, fault codes >> DTC B2955: Security Sensor Data Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the K89 immobilizer control module.
  2. Ignition OFF, test for less than 50 Ω between the low reference circuit terminal 1 and ground.
  3. If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  4. Connect a test lamp between the B+ circuit terminal 3 and ground.
  5. While observing the test lamp, turn the ignition ON. The test lamp should illuminate or flash for three seconds.
  6. If the test lamp does not illuminate or flash, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  7. Test for 11-13 V between the serial data circuit terminal 2 and ground.
  8. If less than the specified range, test the serial data circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  9. If greater than the specified range, test the serial data circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
  10. If all circuits test normal, replace the K89 immobilizer control module. Verify DTC B2955 is not set.
  11. If the DTC is set, replace the K9 BCM.
scientia non olet · About LEMON Manuals