Test Notes

When measurements are requested in the diagnostic charts, use SA 91114NE digital multimeter with correct terminal adapter from SA 9206Z. When a check for proper connection is requested, refer to "Intermittents and Poor Connections in Diagrams". When a wire connector or terminal repair is requested, use the proper repair parts and refer to "Wiring Repairs".

CAUTION: BE CAREFUL WHEN YOU HANDLE A SENSING AND DIAGNOSTIC MODULE (SDM). DO NOT STRIKE OR JOLT THE SDM. BEFORE APPLYING POWER TO THE SDM:
- REMOVE ANY DIRT GREASE, ETC. FROM THE MOUNTING SURFACE.
- POSITION THE SDM HORIZONTALLY ON THE MOUNTING SURFACE.
- TIGHTEN ALL OF THE SDM FASTENERS AND SDM BRACKET FASTENERS TO THE SPECIFIED TORQUE VALUE.

FAILURE TO FOLLOW THE CORRECT PROCEDURES COULD CAUSE AIR BAG DEPLOYMENT PERSONAL INJURY OR UNNECESSARY SIR SYSTEM REPAIRS.