LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2000 >> LS2 Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Trouble Shooting >> System Operation Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

System Operation Check

NOTE: Ignition switch must be in RUN position for all system checks.
  1. Pull wiper lever toward you and release. Washer will operate, and wipers will continue for 2-3 cycles after spray has stopped.
  2. Move wiper/washer switch to INT position, and rotate INT switch to each position and let wipers cycle. Position "3": wipers cycle about every 2 seconds. Position "2": wipers cycle about every 7 seconds. Position "1": wipers cycle about every 12 seconds.
  3. Move INT switch to position "2" and pull lever toward you for 1-2 seconds. Washer should operate while lever is held. Wipers should operate at low speed for 2-3 cycles after spray stops.
  4. Move wiper/washer switch to LOW (LO) position. Wipers should run at low speed.
  5. Move wiper/washer switch to HIGH (HI) position. Wipers should run at high speed.
  6. Move wiper/washer switch to OFF position. Wipers should run at low speed, and then park at bottom of windshield.
  7. Move wiper/washer switch to MIST position. Wipers should wipe one time and return to Park position.
  8. If system does not operate as specified, check self-diagnostic system. See SELF-DIAGNOSTIC SYSTEM  .
scientia non olet · About LEMON Manuals