LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2002 >> Vue 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1631 (Body Control System) >> Repair Instructions >> Body Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Ion 3, 2003 Saturn Ion 2, and 2003 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
  2. Remove the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
    3. Fig 1: View Of Wiring Harness Center Support Bracket
    GM877821Courtesy of GENERAL MOTORS CORP.
  3. Remove the wiring harness rosebud from the right center support bracket.
    4. Fig 2: View Of Center Support Bracket
    GM877820Courtesy of GENERAL MOTORS CORP.
  4. Pull back the carpet at the bottom of the right center support bracket and remove the lower nuts.
  5. Remove the center support bracket nuts and remove the bracket.
    6. Fig 3: View Of BCM Body Harness Connectors
    GM877745Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the small body harness connector (1) from the body control module (BCM).
  7. Disconnect the large body harness connector (2) from the BCM.
    8. Fig 4: View Of BCM I/P Wiring Harness Connectors
    GM877747Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the small instrument panel (I/P) wiring harness connector (1) from the BCM.
  9. Disconnect the large I/P wiring harness connector (2) from the BCM.
  10. If equipped with Onstar, disconnect the OnStar connector.
    11. Fig 5: View Of BCM
    GM877750Courtesy of GENERAL MOTORS CORP.
  11. Remove the BCM nuts and remove the BCM from the vehicle.
scientia non olet · About LEMON Manuals