LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Lighting System) >> Repair Instructions >> Headlamp Bulb Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Headlamp Housing, Park/Turn Bulb Access Opening, & Grommet
    GM1409712Courtesy of GENERAL MOTORS CORP.
  1. To replace the wiring harness, perform the following steps:
    1. Install the wiring harness through the park/turn bulb access opening starting with the headlamp connector (3).
    2. Push the headlamp connector up into the headlamp opening.
    3. Pull the 6-pin connector through the grommet opening in the headlamp assembly.
    4. Pull the grommet. Seat the grommet into the opening (1)
    5. Fasten the 6-pin connector to the tab on the headlamp housing (2)
    2. Fig 2: View Of Park/Turn Bulb
    GM864056Courtesy of GENERAL MOTORS CORP.
  2. Install the park/turn bulb into the bulb socket.
    3. Fig 3: View Of Park/Turn Bulb Socket
    GM864055Courtesy of GENERAL MOTORS CORP.
  3. Install the park/turn bulb socket into the headlamp housing by rotating the socket clockwise.
    4. Fig 4: Installing Park/Turn Bulb Access Cover
    GM864054Courtesy of GENERAL MOTORS CORP.
  4. Install the park/turn bulb access cover by rotating the cover clockwise.
    5. Fig 5: View Of Headlamp Bulb, Housing, & Electrical Connector
    GM864057Courtesy of GENERAL MOTORS CORP.
  5. Install the headlamp bulb into the headlamp housing.
  6. Install the headlamp bulb retaining nut over the headlamp bulb. Rotate the nut clockwise until the nut is locked.
  7. Connect the headlamp bulb electrical connector.
    8. Fig 6: Installing Park/Turn Bulb Access Cover
    GM864054Courtesy of GENERAL MOTORS CORP.
  8. Install the headlamp bulb access cover by rotating the cover clockwise.
    9. Fig 7: View Of Headlamp Assembly
    GM864052Courtesy of GENERAL MOTORS CORP.
  9. Position the headlamp assembly to the vehicle.
  10. Connect the electrical connector to the headlamp assembly.
  11. Install the headlamp assembly retaining pins by pushing down on the pins.
    IMPORTANT: Ensure that the retaining pins are fully seated in the headlamp bracket.
  12. Close the hood.
scientia non olet · About LEMON Manuals