Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stop Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Connect the stop lamp switch electrical connector.
Insert the stop lamp switch into the retainer.

NOTE: Refer to Fastener Notice .

Fig 2: View Of Accelerator Pedal

Courtesy of GENERAL MOTORS CORP.

Install the accelerator pedal to the dash panel. Install the retaining nuts.
Tighten: Tighten the accelerator pedal retaining nuts to 10 N.m (89 lb in).
Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .