Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the bulbs to the tail lamp, backup lamp, and/or side marker lamp sockets.
Install the tail lamp and/or backup lamp sockets to the tail lamp. Rotate the sockets clockwise until the locking tabs are fully seated.
Install the side marker lamp socket to the tail lamp. Rotate the socket clockwise until the socket is fully seated.
Connect the electrical connector to the tail lamp wiring harness.
Position the tail lamp to the quarter panel.

NOTE: Refer to FASTENER NOTICE .

Install the tail lamp screws to the tail lamp.
Tighten: Tighten the tail lamp screw to 2 N.m (18 lb in).
Close the rear compartment.