Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connectors.
- Insert the amplifier rear tabs in the window shelf.
- Push up to engage the amplifier bracket forward clip.
- Raise the rear seat backs.
- Press down over the latch locations to ensure that the latches engage.
- Pull up on the seat backs to ensure that the seat back latches are fully engaged.
- Verify that the seat belts operate properly.
- Refer to Control Module References for programming and setup information.