Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stop Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Connect the stop lamp switch electrical connector.
Insert the stop lamp switch into the retainer.

NOTE: Refer to Fastener Notice .

Fig 2: View Of Accelerator Pedal

Courtesy of GENERAL MOTORS CORP.

Install the accelerator pedal to the dash panel. Install the retaining nuts.
Tighten: Tighten the accelerator pedal retaining nuts to 10 N.m (89 lb in).
Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .