Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Make sure that the ignition coil seals are properly seated to the valve cover.

Install the ignition coil.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition coil retaining bolts.
Tighten: Tighten the ignition coil retaining bolts to 10 N.m (89 lb in).

Fig 1: View OF Ignition Coils

Courtesy of GENERAL MOTORS CORP.

Replace the ignition coil connectors.