Installation Procedure

Route the shift lock control solenoid wires through the opening in the control assembly.

Fig 1: Removing & Installing Shift Lock Control Solenoid

Courtesy of GENERAL MOTORS CORP.

Insert the wire terminals into the connector body.

Fig 2: Inserting Solenoid Electrical Terminals Into Connector Body
Courtesy of GENERAL MOTORS CORP.
Position the solenoid to the control assembly and install the solenoid pop rivet with a rivet gun.

Fig 3: Attaching Shift Lock Control Solenoid With Rivet Gun
Courtesy of GENERAL MOTORS CORP.
Install the automatic transaxle control assembly. Refer to Shift Control Replacement in Automatic Transaxle - 4T40-E/4T45-E.
Enable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.