Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Route the shift lock control solenoid wires through the opening in the control assembly.

Fig 1: Removing & Installing Shift Lock Control Solenoid

Courtesy of GENERAL MOTORS CORP.

Insert the wire terminals into the connector body.

Fig 2: Inserting Solenoid Electrical Terminals Into Connector Body
Courtesy of GENERAL MOTORS CORP.
Position the solenoid to the control assembly and install the solenoid pop rivet with a rivet gun.

Fig 3: Attaching Shift Lock Control Solenoid With Rivet Gun
Courtesy of GENERAL MOTORS CORP.
Install the automatic transaxle control assembly. Refer to Shift Control Replacement in Automatic Transaxle - 4T40-E/4T45-E.
Enable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.