Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Install the antenna cable at the radio.
Install the radio wire harness connector.

Fig 1: Removing Radio Screws

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Install the radio.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the radio screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the HVAC control module. Refer to HVAC Control Module Replacement in HVAC Systems - Manual.
Install the I/P center trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gages and Console.