LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pedal Position Sensor Screw
    GM1204637Courtesy of GENERAL MOTORS CORP.
  1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
  2. Position the sensor fork to the pin.
  3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.
    4. NOTE: Refer to Fastener Notice .
  4. Install the brake pedal position sensor screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    5. Fig 2: Electrical Connector & CPA
    GM1204640Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2).

    Engage the CPA. The CPA will not engage if the connector is not attached properly.

  6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration .
  7. Install the I/P insulator. Refer to Instrument Panel Insulator Panel Replacement .
scientia non olet · About LEMON Manuals