Rear Toe Adjustment

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Make any adjustments to camber before setting toe.

Fig 1: Locating Rear Inner Link Adjustment Hex

Courtesy of GENERAL MOTORS CORP.

Loosen the jam nut (6) at the rear wheel tie rod.
Adjust the toe to the proper setting by turning the inner link adjustment hex (4). Refer to Wheel Alignment Specifications .

NOTE: Refer to Fastener Notice .

When the toe adjustment is correct, tighten the jam nut.
Tighten: Tighten the nut to 62 N.m (45 lb ft).
Recheck the toe alignment.