Scan Tool Output Controls
WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
BCM
| Scan Tool Output Control | Additional Menu Selection | Description |
|---|---|---|
| Wiper Motor Low | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper 1 relay On and Off. The wiper motor will operate at Low speed when the wiper 1 relay is On. |
| Wiper Motor Delay Pos. 1 | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper motor to run through one complete wipe cycle every 11 seconds when the vehicle is at 0 mph. |
| Wiper Motor Delay Pos. 2 | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper motor to run through one complete wipe cycle every 9 seconds when the vehicle is at 0 mph. |
| Wiper Motor Delay Pos. 3 | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper motor to run through one complete wipe cycle every 7 seconds when the vehicle is at 0 mph. |
| Wiper Motor Delay Pos. 4 | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper motor to run through one complete wipe cycle every 5 seconds when the vehicle is at 0 mph. |
| Wiper Motor delay Pos. 5 | Body and Accessories / Wiper/Washer Systems / Special Functions | This output control commands the wiper motor to run through one complete wipe cycle every 3 seconds when the vehicle is at 0 mph. |