LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Entertainment Systems) >> Repair Instructions >> Radio Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radio Electrical/Audio/Coaxial Electrical Connectors
    GM319670Courtesy of GENERAL MOTORS CORP.
  1. Connect the coaxial cable connector to the radio.
  2. Connect the electrical/audio connectors to the radio.
  3. Install the radio to the I/P.
    IMPORTANT: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

    Align the radio control locator tab to the I/P locator hole while carefully pressing the radio into the I/P until fully seated.

    4. Fig 2: Identifying Radio Screws
    GM319664Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the radio screws.

    Tighten:  Tighten the radio screws to 2.5 N.m (22 lb in).

  5. Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory or to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek) or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous) in Instrument Panel, Gages and Console.
  6. Perform the radio set-up procedure. Refer to Radio Setup .
scientia non olet · About LEMON Manuals