LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 5AT - Introduction & Repair Instructions >> Repair Instructions >> Output Speed Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Input/Output Speed Sensor, Bolt & Screw
    GM1230002Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the new output speed sensor O-ring seal.
  2. Install the new output speed sensor O-ring seal onto the output speed sensor.
  3. Install the output speed sensor into the transmission case assembly.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the output speed sensor bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb. in.).

  5. Connect the wiring harness to the output speed sensor.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals