Installation Procedure
WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the power window switch into the pull cup until the locking tabs engage.
- Connect the power window switch electrical connector.
- Insert the forward end of the pull cup into the door trim and push forward to engage the hook.
- Press down on the rearward end of the pull cup.
- Install the pull cup screws.
Tighten: Tighten the screws to 2.5 N.m (23 lb in).
- Reposition the pull cup liner.
NOTE:
Refer to Fastener Notice in Cautions and Notices.