Variable Valve Timing Solenoid: Service and Repair

Oil Flow Control Module Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the oil filter.




3. Remove the oil flow control module.
4. Clean and inspect the oil flow control module sealing area.

Installation Procedure




1. Install a NEW oil flow control module screen.

Notice: Refer to Fastener Notice.

2. Install the oil flow control module and bolts.

Tighten the bolts to 22 N.m (16 lb ft).

3. Install a new oil filter.
4. Refer to Control Module References for programming and setup information. Programming and Relearning