LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls - Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Crankshaft Position Sensor
    GM894668Courtesy of GENERAL MOTORS CORP.
  1. Make sure the O-ring is on the CKP sensor and lubricate the O-ring with mineral oil based grease.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor and the attachment bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 8 N.m (71 lb in).

  3. Lower the vehicle.
  4. Connect the CKP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
scientia non olet · About LEMON Manuals