Camshaft Position Sensor Replacement - Intake

Camshaft Position Sensor Replacement - Intake

Removal Procedure





1. Remove the fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement (Service and Repair) .
2. Disconnect the engine wiring harness electrical connector (2) from the intake camshaft position (CMP) sensor.




3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.



Installation Procedure






Important: Inspect the CMP sensor for damage, replace as necessary.


1. Lubricate the CMP sensor O-ring seal with clean engine oil.
2. Install the CMP sensor.
Notice: Refer to Fastener Notice (Fastener Notice) .


3. Install the CMP sensor bolt.

Tighten the bolt to 10 N.m (89 lb in).





4. Connect the engine wiring harness electrical connector (2) to the intake CMP sensor.
5. Install the fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement (Service and Repair) .