LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2009 >> Sky Red Line, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L - DTC P0700 To DTC P2544 >> DTC P2127 or P2128 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

  1. Ignition OFF, disconnect the accelerator pedal harness connector at the accelerator pedal. Allow sufficient time for the ECM to power down.
  2. Test for less than 3 ohms between the low reference circuit terminal 5 and ground.
    • If greater than 3 ohms, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between 5-volt reference circuit terminal 1 and ground.
    • If less than 4.8 volts, test the 5-volt reference circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the control module.
    • If greater than 5.2 volts, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the control module.
  4. Ignition ON, verify the scan tool APP sensor 2 voltage is less than 0.1 volt.
    • If greater than 0.1 volt, test the APP sensor 2 signal circuit terminal 6 for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Install a 3A fused jumper wire between the signal circuit terminal 6 and the 5-volt reference circuit terminal 1 of the APP sensor 2, and verify that the APP sensor 2 voltage is greater than 4.8 volts.
    • If less than 4.8 volts, test the APP sensor 2 signal circuit for an open/high resistance, or short to ground. If the circuit tests normal, replace the control module.
  6. If all circuits test normal, replace the accelerator pedal.
scientia non olet · About LEMON Manuals