Installation Procedure

WARNING: This page is about a different car, the 2008 Saturn Outlook, 2008 GMC Acadia, and 2008 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front & Rear Bushings

Courtesy of GENERAL MOTORS CORP.

Position the front and rear bushings so that they are equally in the control arm.
Position the CH-48107 on the front bushing.
Using the vise, compress the front and rear bushings until they are seated.
Remove the lower control arm from the vise.
Remove the CH-48107 from the front bushing.
Install the lower control arm in the vehicle. Refer to Lower Control Arm Replacement .