Torque Specifications

Main Bearing Cap Torque and Sequence





Using several steps, tighten the bolts with SST in the sequence shown in the illustration.
Torque 22 Nm (224 kgf-cm, 16 ft. lbs.)





Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts by 90° in the same sequence as step (g).
Check that each painted mark is now at a 90° angle to the front.

Crankshaft Pulley Torque
Using SST, install the pulley bolt.
Torque 128 Nm (1,305 kgf-cm, 95 ft. lbs.)

Connecting Rod Torque
Using SST, tighten the bolts in several steps to the specified torque.
Torque 15 Nm (153 kgf-cm, 11 ft. lbs.)
Mark the front of the connecting cap bolts with paint.
Retighten the cap bolts by 90° as shown in the illustration.