Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the tester on.
4. Enter the following menus: Body Electrical/ Combination Meter / Active Test.
5. According to the display on tester, perform the "ACTIVE TEST".

   Combination Meter 

   ACTIVE TEST - COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat Lamp Cruise	Turns on CRUISE main indicator light	ON/OFF	-

   OK: 

   Indicator light comes on/goes off. 

NG: REPLACE COMBINATION METER  (See REMOVAL )

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the tester on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. According to the display on tester, read the "DATA LIST".

   Cruise control 

   DATA LIST - CRUISE CONTROL
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU)/ON or OFF	ON "CRUISE" on OFF "CRUISE" off	-

   OK: 

   When cruise control main switch operation is performed, the result will be same as above. 

NG: REPLACE ECM  (See REMOVAL )

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )