LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2012 >> xB Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (Service Information) >> Accelerator Pedal Rod >> On-Vehicle Inspection >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1, Accel Sensor Out No. 2.
    5. Read the value displayed on the tester.

      Accel Sensor Out No. 1 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Accel Sensor Out No. 2 Standard Voltage

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals