Installation

FA20 ENGINE CONTROL: VACUUM SENSOR: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

(a) Apply a light coat of engine oil to a new O-ring and install it to the manifold absolute pressure sensor.

(b) Install the manifold absolute pressure sensor with the bolt.

Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

NOTICE:
* If a component has been dropped or subjected to a strong impact, replace it.
* Make sure that the O-ring is not damaged or does not jump out of position during installation.

(c) Connect the manifold absolute pressure sensor connector.

2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation