Front Seat Inner Belt Assembly: Installation: Installation

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side) 
   1. Temporarily install the front seat inner belt with the nut.
      Fig 1: Temporarily Installing Front Seat Inner Belt LH With The Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Attach the 6 wire harness clamps.
   3. Attach the claw to connect the connector to the front seat cushion spring.
   4. Connect the wire harness to the seat slide position sensor protector.
      Fig 2: Connecting Wire Harness To Seat Slide Position Sensor Protector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Connect the connector to the seat position airbag sensor.
   6. Tighten the nut.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE:

      Do not allow the anchor part of the front seat inner belt to overlap the protruding part of the front seat cushion spring.

      TEXT IN ILLUSTRATION
      
      

      *1	Front Seat Inner Belt Anchor Part
      *2	Protruding Part

2. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side) 
   1. Temporarily install the front seat inner belt with the nut.
      Fig 3: Temporarily Installing Front Seat Inner Belt RH With Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Attach the wire harness clamp and connect the connector.
   3. Tighten the nut.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE:

      Do not allow the anchor part of the front seat inner belt to overlap the protruding parts of the front seat cushion spring.

      TEXT IN ILLUSTRATION
      
      

      *1	Front Seat Inner Belt Anchor Part
      *2	Protruding Part

3. INSTALL FRONT SEAT ASSEMBLY LH 

   Refer to INSTALLATION

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
   NOTE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

5. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side) 

   Refer to INITIALIZATION

6. PERFORM DIAGNOSTIC SYSTEM CHECK (for Driver Side) 

   Refer to DTC CHECK / CLEAR

7. PERFORM DIAGNOSTIC SYSTEM CHECK (for Front Passenger Side) 
   1. Perform a diagnostic system check of the SRS system. Refer to DTC CHECK / CLEAR .
   2. Perform a diagnostic system check of the occupant classification system. Refer to DTC CHECK / CLEAR .
8. CHECK SRS WARNING LIGHT 

   Refer to DIAGNOSIS SYSTEM

9. CHECK FRONT SEAT ASSEMBLY (w/ Seat Heater System) 
   1. Check the seat heater operation.
      1. Turn the ignition switch to ON.
      2. Turn the seat heater switch on.
      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.